DIY Car Truck PU Leather Steering Wheel Cover With Needles and Thread Universal
Product Name: Steering Wheel Cover
Color: Black Cover+Black line , Black Cover+Red line
Material: PU Leather added with superfine fiber
Dimension: Approx 532mmx107mm/ 20.94"x4.21"
Fitment: for 37-38cm outer diameter steering wheel
-- DIY your Steering Wheel
-- PU Leather added with superfine fiber
-- it is more wear-resisting and softer.
-- Soft, clean, pore exquisite and comfortable handle
-- It's very fashion and easy to operate
Fit for steering wheel outside diameter: 37-38cm/14.6-15.0inch(Approx)
The measurement allowed error is +/- 1-3 cm.
(Please Compare The Size fit your car Before Purchase!)
① First clean the steering wheel and put the steering wheel cover on the steering wheel.
② Put on the line in the needle and start sewing
③ Pass the line through the inner side of the steering wheel cover, and leave 6 cm on the end rope after knotting.
④ The sewing is started from the outside of the steering wheel cover, the needle is transmitted from the outside to
the inside, and the other side is the same, and the subsequent steps are the same.
⑤ When sewing to the steering wheel ,hold few stitches in the middle of the steering wheel.Then slowly tighten the
rope to make the holster fit on the steering wheel
⑥ Next, take the line from the side of the steering wheel and wear 2-3 pins to bypass the plate.
⑦ Pull the line up to continue sewing and sew as in step three.
⑧ Same hold few stitches in the middle of the steering wheel.Then slowly tighten the rope to make the holster fit on
the steering wheel
⑨ When sewing to the last stitch, it is knotted with the beginning of the line thread, and finally the knot is stuffed into
the inside of the holster.
1 X Steering Wheel Cover
1 X Needle
1 X Thread